The problem is the replacement ejector was oversized and the spring won't push it back out since its been pressed all the way in. Removing the original ejector wasn't the problem it was ejected on its own.
AR15 EJECTOR INSTALL
So the easy way to install the extractor if you don't have a extractor install tool, use the ejector with a spent case to cam the extractor in place and the roll pin just started, used a punch up through the bottom roll pin channel to make sure that the extractor side relief slot is lined up, the drive the roll pin into potion. Hence most of the time that the extractor is binding up, it due to the extractor side releif channel not aligned with the roll pin channel when the roll pin is being drive in place, which just bends the hell out of the roll pin to cause the problem in the first place. Just look at the video below without clicking on the link, and you can see the extractor weep hole in the side of the bolt, and if you look closely at the hole, can see the end of the extractor spring inside the weep hole as well.Īs for once the extractor and spring are out, chase the extractor channel in the bolt face with a drill bit to remove any burs where the roll pin drives through, then chuck the extractor up in a drill to clean any burs from the releif side channel in it.Īs for reinstalling the extractor, make sure that you have the side releif channel aligned with the roll pin channel when you drive the Roll pin in place. Not only does the back of the ejector channel have a weep channel that you can use compressed air to blow it out, most of the time the weep channel does not even need to be used.īreak out a punch, and use it to drive the ejector deeper into the bolt channel with some mallet love taps and the ejector to spring back up between taps, which will allow the extractor roll pin releif channel burs to break off and allow the extractor with spring to snap out of the channel.Īlso, as you have figured out by now, the extractor roll pin needs to be removed, and help to add some CLP into the bolt face channel that way, into the roll pin channel that way, and to just flood the spring section of the ejector through the weep channel as well.
0 kommentar(er)
